brands of guns Automatic weapon identification

Automatic identification and types of weapons

brands of guns Automatic weapon identification

Automatic weapon identification.

When a hard surface metal mixes with pressure or injury with soft metal, special marks of hard metal surface are recorded on the surface of the soft metal. These special signs on soft metal are the optical mirror and the number of such marks. Why are they not received on soft metal, they will be the same every time and if they go through a weapon, they will not be compatible with each other, but these marks will not be compatible with other metal signals. When there is a metallurgy metal full of raw material, it is used to prevent excessive waves and sores at the surface. The sandwich is because the sandwich will be incompatible with the intake or scratch tool or the angle of the rig material that is initially used, and the end of the device will not be compatible with them, since initial ventilation areas can not be found in the same way, Other levels will be used to complete, so after the polishing surface, that paragraph keeps all the special marks in its place, and such marks are not on the other side of the map and similar parts should not be the same. Why not be prepared in a stick, immediately after this important principle, help in establishing the arms identification. The marks on the shell and the bullet, which are produced by a weapon, are similarly possible to achieve other weapons, and maintaining the same principles, the basis of fire-fighting science was founded on the basis of a formal identification of the arms fire since 1930. Start marks that can be seen on the shell and tablet



1- Punctuation pin marks                2- marks of badge fees

3- Chamber marks                           4- Lines and gridges marks

5- Exterior marks                            6- Scars of scaffolding